Hanger

I needed a hanger that can be attached to horizontal surface (like a shelf). Found none. Designed one. This is not perfect and will likely have some more versions to follow. The hanger itself turned out to be a little to small so I will defenitely create a bigger, thicker version.

Original hanger is 5cm long and intended to be attached via 3mm screws.



Printing:

No special settings. I used infill 20%. The hanger is printed on the side to avoid need for supports (that was one of design assumptions). Screw holes might look a little bad after printing but they are not visible when the screw is in place.