Thingiverse
Hanger
door sirtopp
8
Downloads
5
Likes
0
Makes
I needed a hanger that can be attached to horizontal surface (like a shelf). Found none. Designed one. This is not perfect and will likely have some more versions to follow. The hanger itself turned out to be a little to small so I will defenitely create a bigger, thicker version.
Original hanger is 5cm long and intended to be attached via 3mm screws.
Printing:
No special settings. I used infill 20%. The hanger is printed on the side to avoid need for supports (that was one of design assumptions). Screw holes might look a little bad after printing but they are not visible when the screw is in place.
Original hanger is 5cm long and intended to be attached via 3mm screws.
Printing:
No special settings. I used infill 20%. The hanger is printed on the side to avoid need for supports (that was one of design assumptions). Screw holes might look a little bad after printing but they are not visible when the screw is in place.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
