Thingiverse
Hanging Hook (using TULAS)
por Wim_V
6
Descargas
6
Likes
0
Makes
1st example with the use of TULAS.
The flexible loop connection is made with a few cm's of TPU filament.
For more info on TULAS, how to connect the filament and how to use it with your own models:
TULAS: the universal hanging/strapping system
Note: As a TPU filament I tested with Ninjatek Ninjaflex which has a hardness of 85A. If you use TPU with a higher hardness (e.g. 95A) you cannot pull such tight knots and the chambers for the knots are too small. So use TPU of 85 Shore or lower.
The flexible loop connection is made with a few cm's of TPU filament.
For more info on TULAS, how to connect the filament and how to use it with your own models:
TULAS: the universal hanging/strapping system
Note: As a TPU filament I tested with Ninjatek Ninjaflex which has a hardness of 85A. If you use TPU with a higher hardness (e.g. 95A) you cannot pull such tight knots and the chambers for the knots are too small. So use TPU of 85 Shore or lower.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
