Thingiverse
Hardcore stringing test
von bassbeat4life
8
Downloads
6
Likes
0
Makes
It looks easy to print but its not. If you set your retraction right you will be able to print it without stringing. If your settings are off you will notice strings already from the start, if they are just slightly off you will notice stringing on the little towers behind the arc almost at the end of the print.
It uses just 1g of filament to print.
It uses just 1g of filament to print.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!