Thingiverse
Harddisk Board Mounting Bracket
por Workshopshed
12
Descargas
4
Likes
1
Makes
I needed to mount a 3.5inch hard disk on a board for a clustering project I was working on so I made a couple of little brackets to screw it down.
I printed it in ABS and on its side for strength. If you were using a softer material such as PLA you might want to make the brackets a bit bigger.
I printed it in ABS and on its side for strength. If you were using a softer material such as PLA you might want to make the brackets a bit bigger.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
