MakerWorld
Organizers
Zum Modell
Hat Rack (Parametric) V2
80
Downloads
13
Likes
60
Makes
A rack to hang your hats on. Designed to slot over an existing hook, and hang down with multiple spots for hats. Fully parametric! Customize the heights, lengths, thicknesses, widths, hook spacing/ amount, and chamfers. V2 Update:Based on feedback on V1, I tried to make it easier to stack hats by adding a horizontal section of each hook between the spine and the original diagonal piece. I also added two new parameters to customize, hook horizontal section length, and variance (how much the length changes from hook to hook). The V1 version is now as if the horizontal section length is set to zero. Hope this helps!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
