Slicer Discord
Hate Ticks? – 3D-Druckmodell von Thingiverse Thingiverse

Hate Ticks?

von jpearce
60 Downloads
73 Likes
1 Makes
Zum Modell
This is an experimental device to remove ticks. Put tick through the big hole - flat side against your skin. Pull along skin while pressing down to force the tick down the channel. Make sure you get the 'blades' under the head. Fortunately, we are at the end of tick season here...

I make no warranties that this will actually do anything useful or keep ticks from vomiting disease into your bloodstream. If you do happen to get a tick, print it out, give it a try before you reach for the tweezers and let me know how it went. Thanks!

This component is part of an open source lab library, by the [Michigan Tech's Open Sustainability Technology Research Group](http://www.appropedia.org/Category:MOST).

For similar see the [Open-Source Lab How to Build Your Own Hardware and Reduce Research Costs](http://www.appropedia.org/Open-source_Lab)
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen