Hawk 5 camera mount fixed angle

So im flying FPV race. I use the emax hawk 5 frame, which I love. But I crashed 3 FPV cams. So I made this mount with a LOT of protection, the lens is totally sunk into the mount and therefore i can crash all the gates i like with no worrys of my camera.
Im using the Foxeer Predator mikro camera, im pretty sure the mount will work with most mikro cams. The angle is fixed (three versions 45, 50 and 55 degrees. The camera angle is fixed, When the camera lens is pushed down toward the print, this way it will always be in the same angle. However the 50 degrees can be tilted up to - probably 55 degrees, because there is some leverage above the lens. Im using this mount with the picture fliped, that way there is more room between the camera and the stack.
Print in tpu. If runing you camera fliped like me, after printing you will have to cut out the bottom out whith a cuttingplyer in order to make room for the conneter. The bottom layer is only there so it has a base to print on. See the