Thingiverse
HDZero Goggle patch antenna ORT Shield mount
door Iamthemakerofthings
3
Downloads
3
Likes
0
Makes
HDZero Goggle patch antenna ORT Shield mount
Prints standing up without support.
The patch antenna fit really tight. No need to glue them in.
It is not designed to clip on and off everyday. It is designed to stay on the goggle and not fall off. If you are having trouble to remove this from your goggle just warm the PLA slightly, this will make it very easy to remove.
Prints standing up without support.
The patch antenna fit really tight. No need to glue them in.
It is not designed to clip on and off everyday. It is designed to stay on the goggle and not fall off. If you are having trouble to remove this from your goggle just warm the PLA slightly, this will make it very easy to remove.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
