Thingiverse
Headboard Stop
por _slinky_
26
Descargas
16
Likes
0
Makes
When the headboard keeps banging on the wall, simply fit two of these to the back and adjust the knob to tighten the board. You can either stick one side to the wall with 3M tape, or just place it on the back.
In the closed position the height is 30mm and will screw out to 40mm, if you want a taller screw you can increase the Z height for both parts, I have tested the Z height up to 160% and the threads were fine. (opening to 100mm)
As aways with any printed threads, they work better with a little silicone spray at first.
In the closed position the height is 30mm and will screw out to 40mm, if you want a taller screw you can increase the Z height for both parts, I have tested the Z height up to 160% and the threads were fine. (opening to 100mm)
As aways with any printed threads, they work better with a little silicone spray at first.
_slinky_ también publica en
16 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
