Thingiverse
Headphone Stand (Split)
par Gertsen
135
Téléchargements
85
Likes
0
Makes
I split the original model from MakerBot since it was too large for my printer.
Just print:
1 x Top
1 x Bottom
2 x Connector
Unless you have a printer with a very large print area, you will probably need to put the top part at an angle, so you can take advantage of the z-axis space.
The connectors are for the two holes in each part, in some cases they fit so tight that no glue is needed, but even if using glue, they help keep the parts aligned while the glue dries.
I recommend gluing the parts for maximum strength.
Just print:
1 x Top
1 x Bottom
2 x Connector
Unless you have a printer with a very large print area, you will probably need to put the top part at an angle, so you can take advantage of the z-axis space.
The connectors are for the two holes in each part, in some cases they fit so tight that no glue is needed, but even if using glue, they help keep the parts aligned while the glue dries.
I recommend gluing the parts for maximum strength.
Gertsen publie également sur
25 modèles supplémentaires sur 2 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
