Thingiverse
Music
Go to Model
Headphones Hook
7
Downloads
9
Likes
0
Makes
There are many great hooks and holders for headphones. But I needed one that has a flat surface on the back so I can glue or tape it to a flat surface. This one did the trick. Maybe the base plate could be even thinner, feel free to modify it.
Height: 70 mm
Width: 80 mm
Depth: 65 mm
Print instructions:
Rotate it so the backplate is facing down. Then you should be able to print the whole thing without supports.
v2 just has a support beam under the arch. I didn't try printing it, but maybe it's a good idea for heavier headphones.
*You really don't need to, but if you feel inclined, you can tip here:*
https://www.buymeacoffee.com/jymden
Height: 70 mm
Width: 80 mm
Depth: 65 mm
Print instructions:
Rotate it so the backplate is facing down. Then you should be able to print the whole thing without supports.
v2 just has a support beam under the arch. I didn't try printing it, but maybe it's a good idea for heavier headphones.
*You really don't need to, but if you feel inclined, you can tip here:*
https://www.buymeacoffee.com/jymden
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
