Thingiverse
Headrest Hook
door mafiasiegen
9
Downloads
22
Likes
0
Makes
Quick and dirty remix of the wonderful "Chained Headrest Hook".
The original hook tended to fall from the headrest when not in use, so i closed the upper hook to a ring 13mm in diameter, maybe to small for other purposes than the backseat headrests of a suzuki swift, please measure first.
Next problem was: it was a bit too long, so the bags i hang there stood on the floor of the trunk.
Solution: Shortened it by one element.
Print as is. No support needed if printed slow enough.
Sovol SV07:
0,28mm layer
125mm/s
PLA
The original hook tended to fall from the headrest when not in use, so i closed the upper hook to a ring 13mm in diameter, maybe to small for other purposes than the backseat headrests of a suzuki swift, please measure first.
Next problem was: it was a bit too long, so the bags i hang there stood on the floor of the trunk.
Solution: Shortened it by one element.
Print as is. No support needed if printed slow enough.
Sovol SV07:
0,28mm layer
125mm/s
PLA
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
