Heated polycarbonate 3d printer enclosure

Simple enclosure for my Brenda 3d printer.
Should work for other printers as well.

printed parts:
-drillhelp, the hole is a bit closer to the edge (2.5mm) so the round edge of the extrusions stays visible.
-door parts
-lcd holder (doesn't fit perfectly but was good enough for me).
-IEC holder
-the atxboard is you use the board from https://www.staticboards.es/productos/atxboard/
I would advise to use different crimps as the provided solution is a bit high, I used a seasonic sfx 350 watt psu.


things to buy:
-polycarbonate, I found mine pre-cut at a good price here:
https://kunststofplatenshop.be/polycarbonaat-platen/helder/
I used 5mm but if I would have to do it again I would maybe try with less (the doors should be 5), 5mm is ok but the weight is a bit much.
If you want to know all measurements (only usefull when you build the same Brenda printer) let me know.

-extrusions and a couple of squares and a lot of nuts (stainless).
http://www.motedis.com/shop/Slot-pr