Thingiverse
Heating pipe rosette
door Svanne
2
Downloads
2
Likes
0
Makes
We have a heating pipe that is not far enough from the wall so that the standard stuff that you can buy did not fit in there.
I only found the single pipe rosettes but most of the time dirt will stuck between them and i hate it.
So i made this one that fits on both pipes at the same time. No dirt gap between.
print it 2 times - take the Pins and put them together. They hold tight.
I used PLA.
Feel free to costumize and adjust it when your pipes are not fitting in there.
I only found the single pipe rosettes but most of the time dirt will stuck between them and i hate it.
So i made this one that fits on both pipes at the same time. No dirt gap between.
print it 2 times - take the Pins and put them together. They hold tight.
I used PLA.
Feel free to costumize and adjust it when your pipes are not fitting in there.
Svanne publiceert ook op
6 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
