Thingiverse
Hellbot EcoFila Threaded Spool
von koppito
9
Downloads
4
Likes
0
Makes
Hellbot's Ecofila spool upgrade, added a thread in the middle.
Instructions:
1. Align and insert the outer half with the zip ties.
2. Insert the inner half through the thread.
3. Cut the zip ties.
4. Enjoy your new spool of filament!
No supports needed, printed with 0.32 layer height on a Hellbot Magna 2 300.
Instructions:
1. Align and insert the outer half with the zip ties.
2. Insert the inner half through the thread.
3. Cut the zip ties.
4. Enjoy your new spool of filament!
No supports needed, printed with 0.32 layer height on a Hellbot Magna 2 300.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
