Thingiverse
HelloBeePrusa Blower
por Tizz
9
Descargas
7
Likes
0
Makes
Based on the original HBP Blower design I slightly modified this part due to some warping I experienced.
My goal was to raise the blower by a few mm's to give a little more clearance to the bed and to change the angle or remove the curve at the bottom of the blower whilst keeping the original design.
The screw holder was replaced with a longer rectangular holder and a large rectangular opening was added in order for the part to be positioned higher or lower.
All credit for the original design goes to the BEEVERYCREATIVE TEAM
My goal was to raise the blower by a few mm's to give a little more clearance to the bed and to change the angle or remove the curve at the bottom of the blower whilst keeping the original design.
The screw holder was replaced with a longer rectangular holder and a large rectangular opening was added in order for the part to be positioned higher or lower.
All credit for the original design goes to the BEEVERYCREATIVE TEAM
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!