Hellraiser - Pinhead B&W Hueforge

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x121.08mm in sizeYou may print at higher layer heights below the Base Thickness of 0.48mmThe Max allowed Thickness is 2.24mm and the Actual Thickness is 2.24mmFilaments Used: (* = Owned) #000000 * PLA BambuLab Matte Charcoal Transmission Distance: 0.6 #4c5f71 * PLA BambuLab Basic Blue Gray Transmission Distance: 3 #e7ceb5 * PLA BambuLab Basic Beige Transmission Distance: 8 #ffffff * PLA BambuLab Matte Ivory White Transmission Distance: 3.5This print uses 4 unique filamentsSwap Instructions: Start with Charcoal At layer #8 (0.72mm) swap to Blue Gray At layer #13 (1.12mm) swap to BeigeBorder Only Colors from here until the end. At layer #20 (1.68mm) swap to Ivory White for the rest.