Thingiverse
Helping Hand Base
von Alex_Bell
2
Downloads
3
Likes
0
Makes
This thing extends the base of my helping hand to keep the center off mass within the base.
After printing, the base isn't quite snug enough but it does work. I might get around to making it smaller some time.
After printing, the base isn't quite snug enough but it does work. I might get around to making it smaller some time.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
