Hemera (Hermes) mount bracket for BL Touch (BLTouch)

Hi there,

This is a mounting bracket that allows you to attach a BL Touch unit directly to the motor assembly on the E3D Hemera (formerly Hermes) toolhead design.

To make use of this bracket, you will need:

1 x BL Touch Unit (Complete)
1 x Hemera Hot End Assembly (Complete)
4 x M3 Washers (Black Oxide)
2 x M3x12 SHCS (Black Oxide) Screws
2 x M3x35 BHCS (Black Oxide) Screws
2 x M3 Nyloc Nuts (Black Oxide)
1 x (Optional) Black Heatshrink

Reference the picture to look at a 'completed assembly'. The installation is pretty self explanatory. To install, you will need to remove the 2 front-facing philips screws from the Hemera motor itself; they will be replaced with the M3x35 SHCS screws that will run through the bracket and attach the bracket and tighten to the motor.

Pictured here is a BL Touch unit attached to a Hemera design for the Lulzbot Taz (modern carriage), however, given the fixed layout of the Hemera, the design itself should be compatible with any Hemera uni