Thingiverse
Hex Armor Button
von ChaosBunny333
3
Downloads
5
Likes
0
Makes
This is a modification of the Hexagon Armor by PerspexAvenger. I made my 28 mm across instead of his 25mm.
To use this button, punch a hole through your material (using a leather punch or an awl) and insert the pin through the hole. Then dab a bit of glue on the inside of the hole on the top piece and push together.
To use this button, punch a hole through your material (using a leather punch or an awl) and insert the pin through the hole. Then dab a bit of glue on the inside of the hole on the top piece and push together.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
