Thingiverse
Hex Bit Holder
by kumekay
125
Downloads
78
Likes
0
Makes
Hex bit holder with magnets
It uses 8x1mm rare earth magnets to hold bits. Magnets glued with super glue.
It holds not too strong, so it not possible to hold upside down.
Bits are grouped by 4 for easier access,
also you can put here 2 adapters
PS, my print failed on 88%, but I decide to use it as is.
It uses 8x1mm rare earth magnets to hold bits. Magnets glued with super glue.
It holds not too strong, so it not possible to hold upside down.
Bits are grouped by 4 for easier access,
also you can put here 2 adapters
PS, my print failed on 88%, but I decide to use it as is.
kumekay also publishes on
4 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
