Thingiverse
Hex bit rotating holder
von Scofferoff
5
Downloads
3
Likes
0
Makes
A 15 slot rotating holder for your favorite quick change hex bits.
Uses 6mm ball bearings or BBs in the base.
If it doesn't slot together then widen the slot in the center peg a little. It's a tiny part and may warp with FFF printing.
Probably need to stick it down it's so light :)
Uses 6mm ball bearings or BBs in the base.
If it doesn't slot together then widen the slot in the center peg a little. It's a tiny part and may warp with FFF printing.
Probably need to stick it down it's so light :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
