Thingiverse
Hex Key
door Paul020559
9
Downloads
2
Likes
0
Makes
Hex Key
Remixed from my original Hex Driver Bit Holder (Sept 08 2020).
Compact hex driver with magnet to hold hex bit.
Nearly the same as the original but a bit smoother with a space to insert a 6 x 2 mm magnet (easily sourced on Amazon or Ebay).
If you print this version without the magnet the hex bit will be loose (use the previous version for a push fit).
Use the gcode to print directly - otherwise set up your slicer to pause at layer 48 (if using the settings below) and drop in the 6 x 2 mm magnet. Resume print.
SETTINGS:
Orientation already aligned in the files with the open hex face upward
Layer height: 0.2 mm
Infill: 10%
Brim: 4 mm
Supports: None
Material: PLA, PTEG, etc
Regards, Paul
Remixed from my original Hex Driver Bit Holder (Sept 08 2020).
Compact hex driver with magnet to hold hex bit.
Nearly the same as the original but a bit smoother with a space to insert a 6 x 2 mm magnet (easily sourced on Amazon or Ebay).
If you print this version without the magnet the hex bit will be loose (use the previous version for a push fit).
Use the gcode to print directly - otherwise set up your slicer to pause at layer 48 (if using the settings below) and drop in the 6 x 2 mm magnet. Resume print.
SETTINGS:
Orientation already aligned in the files with the open hex face upward
Layer height: 0.2 mm
Infill: 10%
Brim: 4 mm
Supports: None
Material: PLA, PTEG, etc
Regards, Paul
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
