Hex maker widget

Designed as a tool for making hex pieces for battletech using a hot wire. to use it, create a brick 33mm x 38mm and set the brick into the angled part. use the cut out as the guide for your wire and the straight bar rests against your hot wire table guide. slide the widget with foam inserted across the wire and it will make a cut in the corner at the right angle

updated with measurements along the back edge for the narrow and thick edged of a hex for battletech and a better wire guide so that the cutting wire doesnt impact the tool when cutting. advise printing hollow to safe resin. Wuld not recomend PLA, as PLA WILL melt when it comes into contact with hot wire