Hex Stamp Patterns

By request I'm uploading my Hex stamp patterns for 3D Printing. The intent of these patterns, was for them to be used for Halo undersuits. Ideally, you would heat up the foam you are using for the undersuit and then press the stamps into the foam. I would recommend printing in ABS over PLA for this if you are planning on using the 3D print directly, as PLA tends to warp when exposed to high temperatures. If you have the opportunity to cast them in metal, it would definitely help adding the pattern to the foam, as you could heat the stamp up instead of the foam. (If you do this, you might have to send me one!!!) It is also suggested to prepare some overlap when stamping, and blocking the heat off from sections that have already been stamped, as re-heating the foam can cause the details to be lost.