Hex2 Box

I have fine tuned the connectors for this box. they have small tolerances but each one is tapered towards the bottom to allow them to fit a little easier. They can link together to create different designs/combinations. I have included different height versions as well as ones with and without the inside dividers. They are designed to print on a MPMD and use most of the bed. About 85mm at the widest. Inside radius is about 35mm and outside radius is about 42mm.
I didn't want to go much bigger as many people have bed levelling issues with the MPMD if they have not calibrated them properly.
I have included a test print piece that can be used to check the sizing and tolerances.
If you find pieces a little tight try sanding or filing the connectors slightly to remove any roughness or extra filament. If you are finding them difficult to remove place one of the pieces on a counter edge (connectors slightly overhanging) and using a small allen wrench or other small bar tap down on the cent