Hexacopter

My own design hexacopter.
Based around a big battery - hence the dimensions.
Slice and rotate parts the way you like. I've exported them as how they fit together. I printed from PETG, but had occasional parts (back cover, battery enclosure) made out of PLA too.
GPS enclosure printed from transparent PETG, to see the status LEDs.

In my build (and, therefore, all the mounting holes aligned for these parts):
- Battery = 6200mA, 4S
- FC = Matek F405miniTE - right in the centre. Running Arducopter.
- GPS = Matek M10-5883 (enclosure designed for it).
- ESC = two Mamba 4-in-1 sets, one above another, on 1/2 inch standoffs. No overheat issues so far.
- Motors = DJI 2212/2312 920kV or equivalent.
- Gimbal control = StoRM 2 axis clone from Aliexpress (it's the cheapest one, you can't miss).
- Receiver = Flysky FS-A8S (or whatever small receiver you choose - mounts under gimbal board on doublesided tape, feed the antenna outside via front hole.
- Wifi telemetry unit - doublesided t