Hexagonal Peg Board

This pegboard has been designed to have all holes 1" apart from center-to-center. The holes are 1/4" in diameter. Due to printing tolerances, feel free to scale this model slightly to avoid post-processing. Otherwise, just send a 1/4" drill bit through each hole after printing. I recommend printing this part with a hefty amount of infill and at least 5 walls so that the pegs are somewhat load-bearing. Slice with either large face directly on the build plate, no supports required.

7/5/23 - Added a new version that is hollowed out in the back to allow for different hardware mounting. The walls are .100" thick and the cavity is .300" deep. Print face down with the cavity facing up to avoid using support material.