Thingiverse
hexplate
von ChristianSi
33
Downloads
37
Likes
3
Makes
This is a parametric (written in OpenSCAD) derivate of TheKretchfoop's Modular Honeycomb Frame. The corner pieces are designed to be printable without support. I followed Gyrobot's suggestion to chamfer the corner of the corner pieces and put the chamfered edge on the printbed (for corner_middle/corner_top, not required for corner_bottom).
Since I'm currently traveling and don't have a 3D printer nearby, I cannot test whether it works as it should. Feedback most welcome!
Since I'm currently traveling and don't have a 3D printer nearby, I cannot test whether it works as it should. Feedback most welcome!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
