Thingiverse
Higher Flow LARGE Sponge Filter
door pclapp19
5
Downloads
3
Likes
0
Makes
The sponge I use on this I got off Amazon they are about 6" tall and just over 4" diameter.
Print everything at 99% infill
You should not need any supports except for the flow bender, BUT i sliced that into 2 pieces, printed without supports and glued together.
The outer cavity of the base i filled with sand, then glued the lid on.
After that i glued the sponge tube in place.
Then glued the bubbler in place.
Then the bubbler riser to the bubbler
I DID NOT glue the velocity riser to the bubble riser so you can change direction of flow.
I did glue the flow bender to the top of the velocity riser
Print everything at 99% infill
You should not need any supports except for the flow bender, BUT i sliced that into 2 pieces, printed without supports and glued together.
The outer cavity of the base i filled with sand, then glued the lid on.
After that i glued the sponge tube in place.
Then glued the bubbler in place.
Then the bubbler riser to the bubbler
I DID NOT glue the velocity riser to the bubble riser so you can change direction of flow.
I did glue the flow bender to the top of the velocity riser
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
