Thingiverse
Higher Flow LARGE Sponge Filter
par pclapp19
5
Téléchargements
3
Likes
0
Makes
The sponge I use on this I got off Amazon they are about 6" tall and just over 4" diameter.
Print everything at 99% infill
You should not need any supports except for the flow bender, BUT i sliced that into 2 pieces, printed without supports and glued together.
The outer cavity of the base i filled with sand, then glued the lid on.
After that i glued the sponge tube in place.
Then glued the bubbler in place.
Then the bubbler riser to the bubbler
I DID NOT glue the velocity riser to the bubble riser so you can change direction of flow.
I did glue the flow bender to the top of the velocity riser
Print everything at 99% infill
You should not need any supports except for the flow bender, BUT i sliced that into 2 pieces, printed without supports and glued together.
The outer cavity of the base i filled with sand, then glued the lid on.
After that i glued the sponge tube in place.
Then glued the bubbler in place.
Then the bubbler riser to the bubbler
I DID NOT glue the velocity riser to the bubble riser so you can change direction of flow.
I did glue the flow bender to the top of the velocity riser
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
