Thingiverse
Hinge pin
door SirPancakez
25
Downloads
14
Likes
0
Makes
The 10mm bar I had was rather too snug for my liking so I modeled a replacement part with a diameter of 9.8mm to account for my printers inaccuracy. I also added a threaded 4mm hole on one end so it can be pulled out easily.
Hope this is useful to others, total print time was about 4.5 hours with my printers settings.
Hope this is useful to others, total print time was about 4.5 hours with my printers settings.
SirPancakez publiceert ook op
14 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!