Thingiverse
Hinged box, parametric
von torreybird
51
Downloads
23
Likes
0
Makes
3D print a box base and lid, and then connect them together using commerically-available hinges. Default hinge measurements based on uxcell spring-loaded hinges (https://www.amazon.com/dp/B07GB66GPW)
Use OpenSCAD to modify box length, width, height of base, and height of lid.
* boxLength: minimum 24mm, maximum 240mm
* boxWidth: minimum 6mm (but would be silly!), no maximum
* baseHeight: minimum 10mm, no maximum
* lidHeight: minimum 10mm, no maximum
* wallThick: minimum 1mm
* backWallThick (thickness of back wall, which holds springs): minimum 4mm
Use OpenSCAD to modify box length, width, height of base, and height of lid.
* boxLength: minimum 24mm, maximum 240mm
* boxWidth: minimum 6mm (but would be silly!), no maximum
* baseHeight: minimum 10mm, no maximum
* lidHeight: minimum 10mm, no maximum
* wallThick: minimum 1mm
* backWallThick (thickness of back wall, which holds springs): minimum 4mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
