Thingiverse
Hops Tree
par jpmfjc1
0
Téléchargements
0
Likes
0
Makes
You will need (x9) twine that is 3mm thick by 20 Ft.
(x9) 5 Gallon Buckets if you are growing in buckets.
(x1) 10 foot 1- 1/2 PVC pipe.
You can scale it up if you like. The ID diameter of the model is 1.920"
Hops Tree Model goes to the top.
Hops Tree 2 Model goes around the bottom with a hoes clamp to hold it tight to the pole
Hop Tree 3 is the stake for the ground.
Hops Tree 2 Model is your anchor point. Then you loop it through the top. Then to the buckets. This will allow you to extend the pole with another if you need to later on if the bines grow longer.
(x9) 5 Gallon Buckets if you are growing in buckets.
(x1) 10 foot 1- 1/2 PVC pipe.
You can scale it up if you like. The ID diameter of the model is 1.920"
Hops Tree Model goes to the top.
Hops Tree 2 Model goes around the bottom with a hoes clamp to hold it tight to the pole
Hop Tree 3 is the stake for the ground.
Hops Tree 2 Model is your anchor point. Then you loop it through the top. Then to the buckets. This will allow you to extend the pole with another if you need to later on if the bines grow longer.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
