Thingiverse
Horizontal micro servo mounting bracket
von Kennozz
17
Downloads
6
Likes
0
Makes
I designed this mount fast in sketchup for my shovel nose hydroplane.
Should fit al standard micro servos and is meant to be glued to the bottom of the hull.
Mounting holes for the servo are 2mm so the standard screws fit.
I cut the the original mounting screws down to about 8mm and screw them right in.
Should fit al standard micro servos and is meant to be glued to the bottom of the hull.
Mounting holes for the servo are 2mm so the standard screws fit.
I cut the the original mounting screws down to about 8mm and screw them right in.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
