Thingiverse
Hot End
von jlnhab
17
Downloads
59
Likes
0
Makes
My last hot end.
Temperatures were taken with a thermocouple in direct contact with the inside of the nozzle.
The temperature measured at the end of the threaded M6 rod, stabilises at 46°C above the room temperature when the hot end is kept at 250°C.
I had to set the temperature at 273°C in order to reach 250°C.
But I used the distribution table for the thermistor.
Temperatures were taken with a thermocouple in direct contact with the inside of the nozzle.
The temperature measured at the end of the threaded M6 rod, stabilises at 46°C above the room temperature when the hot end is kept at 250°C.
I had to set the temperature at 273°C in order to reach 250°C.
But I used the distribution table for the thermistor.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
