Thingiverse

HoverDrone

von Deanasawr

266 Downloads

206 Likes

0 Makes

This is a waterbottle-sized heli/mono/uni-copter designed to hover in the air at the spot it's first deployed. As opposed to vectoring the propellers to provide directional motion, the center of mass located in the pendulum is shifted instead.

See the assembly better here: http://a360.co/2um5yMn

This build requires:
1x Arduino Nano
1x Bluetooth Module
1x Accelerometer/gyroscope Module
2x Micro Servos
2x ESC (Motor Controller)
1x 1000Kv contra-rotating motor assembly
1x Li-Po Battery
Your favorite semi-permanent adhesive
A few other 3D printed components.

3d printed 3D printing copter diy DIYDRONE Diydrones drone Helicopter monocopter Quadcopter unicopter 3d printed 3D printing copter diy DIYDRONE Diydrones drone Helicopter monocopter Quadcopter unicopter 3d printed 3D printing copter diy DIYDRONE Diydrones drone Helicopter monocopter Quadcopter unicopter 3d printed 3D printing copter diy DIYDRONE Diydrones drone Helicopter monocopter Quadcopter unicopter 3d printed 3D printing copter diy DIYDRONE Diydrones drone Helicopter monocopter Quadcopter unicopter

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat