HTProbe Bed Level Probe

This probe can soon be purchased from https://hightemp3d.com/

This is a challenging build. You can get help on Discord or you can wait and buy it when it is available. The prototype of the probe works amazingly well. The probe is completely unafected by magnetic fields and only thermal expansion influence it. No electronic parts inside the enclosure so this probe handles the temperature of the 3D printed plastic and the string.

This is a remix of Steve Whites Marionette probe. You will need:
- M5 brass washer
- Long M2 thread insert
- Short M2 thread insert
- M2 shoulder bolt 25 mm long
- Spring. Thread diameter:0,32 mm Inner diameter 3,68 mm Length 19.8 mm
- 1.5 mm2 copper wire. Only a few mm needed.
- Wires
- Connector
- Soldering Iron
- Solder
- MG996 servo
- Bowden tube
- Braided fishing line or Kevlar line
- Sand paper
- Steve Whites servo mount for the Marionette probe.

I used ABS for the two printed parts. It is very challenging print, the threads are di