Thingiverse
Hydreon rainsensor holder
von dreidebauer
1
Downloads
2
Likes
0
Makes
I created a custom holder for my Hydreon RG-15 rainsensor, which also fits the RG-9 and RG-11 sensor. the holders length is 299mm/ 11.77 inch
required parts:
2x M6x30 inbus countersink screws
2x M6 nut screw
2x 4mm screw to attach it to your wall
the cable runs nicely inside the holder to cover and protect it from environmental conditions.
required parts:
2x M6x30 inbus countersink screws
2x M6 nut screw
2x 4mm screw to attach it to your wall
the cable runs nicely inside the holder to cover and protect it from environmental conditions.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
