Hydroponic Drain

This is a hydroponic trough drain for rectangular trough NTF systems http://en.wikipedia.org/wiki/Nutrient_film_technique . It's also useful for draining tubs and barrels and uses a standard (even in this metric world) 3/4" BSP threaded section which is just over 1" (26mm) in diameter. There's little logic in those thread naming conventions!

On the pointy end there is a 1/2" (13mm) barb for poking into the drainage tube of aforementioned diameter. Helps to warm the tube in hot water or the sun before fitting the barb.

Fit with an appropriate washer from the hardware store, or squirt a bead of instant gasket on the flange of the drain before screwing it all together. (The nut thread has been tightened up a little in this new version).

This one is printed in Diamond Age PLA, which in non-toxic and lasts well in hydroponic systems.