Hydroponic Tower - Complete (Revised)

I downloaded the original from here, but some things were missing and the print settings were not quite to my taste.Now that I have finished the tower, I would like to share my findings with you :) In the original, all wall thicknesses were specified as 4 in the first print profile - but for most parts, 2 walls are easily sufficient. I would only recommend 4 wall thicknesses for the pot lid, as this is where the entire weight is borne.The file says that it fits a 24cm pot - but I bought one with a 28cm diameter at the DIY store. I simply went to the store with the printed lid and tried out where it would fit best. Snap fit :) The original file contains the 4x-planter with ugly wrinkles (artifacts), I have added a nicer file here so that you don't have the same mistake as me :) I also added more caps and made inlays for them. So you can print them in a different color and then just press them in, fits wonderfully. Otherwise a light tap with a small hammer. If you print a 5x-planter,