Hydroponics

This is a customizable hydroponics system, which means the materials you want varies. For example, if you just want 3 planters, you will need 1 base, and 2 followers. Depending how you connect/attach the units, the number of stoppers and unitconnector will vary. Look further to see the uses of stoppers and unitconnector. Basically you will need to print:1x baseshell1x basecap(#of planters you want)x followershell(#of planters you want)x followercap(a ton of)x stopper(a good amount)x unitconnector ASSEMBLY: (if you don't know how to proceed, please look down at the uses of the pieces section to help)Step 1: First, locate your 3d printed baseshell. If you want to attach another planter to this one, grab a followershell, and connect them with the unitconnector at the paths. Repeat as desired. Block off any remaining paths using stopper so that your system is watertight. In any of these steps, please use hot glue or something to make these parts watertight. Once your system is watertig