MakerWorld
Other Tools
Model downloaden
HydroTool
6
Downloads
1
Likes
6
Makes
This tool is provided as an alternative to the Flex Strap Customizer Tool for easier removal and installation of custom 3D printed straps/handles for Hydro Flask strap lids. A length of approximately 180mm of ~1-2mm cord is needed for installing the straps.Simply feed the cord through the smallest hole through which it fits on Part A and tie a knot, then do the same for Part B. Use the tool as shown in the video at the link above.
TEAWRECKS publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
