Hyper Tough Stack Gridfinity Base 3Drawer Tool Box

Split Gridfinity 7×5 base for Hyper Stack Tool box 3 drawer. These bases fit the bottom 2 of the 3 drawers that are deep. Not the top drawer. I used Gridfinity Generator found here. Then made my own cubed spacers within Bambu studio. There’s 2 designs: Style A and Style B Style A. Uses full 42 mm pitch with offset slim borders to fit around molded walls. Two plates (4×5 + 3×5) with 19 mm clearance strips on one side. Style B. Uses a 6x5 base plate and then a 2x5 plate with one column narrow sitting at around 37.8mm wide and not the standard 42. Will be doing bins to fit that custom size eventually.Two plates (6x5 + 2x5 w/narrow column) For both Styles there are (7)Spacers that go alongside them. 6 underneath: 2 in each section. So that the grid doesn’t sag into the drawer from weight. And a C style spacer that goes towards the front of the drawer to stop frontward sliding. This is my first time trying make a custom fit project. Thank you.