Thingiverse
Hypercube 2020 LED mounting brackets
von STIG_
31
Downloads
15
Likes
0
Makes
Simple and effective way to provide much needed lighting to any Hypercube.
LEDs from amazon:
https://www.amazon.com/gp/product/B017A26OU0/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1
The glue on the back of the LEDs is junk, wont hold ANY weight. A bit of gel superglue does the trick. This bracket are press fitted to the 8020.net extrusions which have a 5.26mm channel. WILL NOT WORK on other extrusions that have a 6mm channel.
The brackets have a 60 deg angle to provide as much light to the printed part at any height.
LEDs from amazon:
https://www.amazon.com/gp/product/B017A26OU0/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1
The glue on the back of the LEDs is junk, wont hold ANY weight. A bit of gel superglue does the trick. This bracket are press fitted to the 8020.net extrusions which have a 5.26mm channel. WILL NOT WORK on other extrusions that have a 6mm channel.
The brackets have a 60 deg angle to provide as much light to the printed part at any height.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
