Hypercube Direct Drive Mount

This is a remake of Scott_3D and AMIDE mounts for the Hypercube Evolution printer extruder. I was wanting to mount my TriangleLab Direct Drive extruder, but I could not find a mount that I liked. AMIDE came close but she had the BLTouch mount on the left and I wanted to keep it on the right as it currently is. So, I took AMIDE’s and Scott_3D’s mount and combined them into one single mount. If you use Scott_3D mounts, you will be able to reuse the X-carriage mount for this to attach to. This has taken several months to work out the kinks, but I think I have a good working model now. However, here are a few things to note:

Prior to any assembling of any of the parts, I have found it is best to pre-thread all of the screw holes with an M3 screw. I have deliberately made these holes a little smaller to give the screws something to bite into. By threading a screw in prior to assembly, it will make assembly a lot easier. Also, pay special attention to the screw holes for the 30x30 fan. Th