Thingiverse
HyperCube, E3D mount without blowing
por saschai
26
Descargas
10
Likes
0
Makes
I'm slowly collecting a new HyperCube
Last night I printed the carriage of the X-axis.
A few hours earlier was an update.
I realized this, only after the end of printing :))))).
I print ABS plastic, without blowing.
I used the idea of this holder https://www.thingiverse.com/thing:1876861 and made holder for new versions X carriage.
Adapted for ABS printing with plastic.
I'll check in live only next week, but there should not be any problems!
Last night I printed the carriage of the X-axis.
A few hours earlier was an update.
I realized this, only after the end of printing :))))).
I print ABS plastic, without blowing.
I used the idea of this holder https://www.thingiverse.com/thing:1876861 and made holder for new versions X carriage.
Adapted for ABS printing with plastic.
I'll check in live only next week, but there should not be any problems!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
