HyperCube Evo Cable Chain

I wanted a good cable chain setup for my Hypercube Evolution, but I couldn't find anything I liked. I didn't want a chain that just flops around in the wind. I wanted it more constrained to give a better look. So I designed my own.

It was brought up to my attention that there are a couple flaws in my first design.

1) The fan will hit the chain on the right side
2) the right optical endstop can not be triggered because of problem #1
3) the chain can hit the belts in the back on some cases.

Some people were asking for a video of the chain in motion. You ask, and you shall receive.... https://youtu.be/J3iaaZ_WJgY

This setup will work with Scott_3D's standard setup with very little work.

Access to the bolt on the carriage for tool changing is still accessible with a little work and planing.

I took the measurements from ModelStation's chains, redrew them, and did some changes in the opening for the wires. It should prevent the wires from being snagged while in use. Eve