Hypercube Evolution Corner Bracket w/wire & Reverse Bowden Holder

I remixed this corner bracket to include a loop on the back for hot end wiring to run through as well as a spot for my PTFE tube that runs from the corner of the machine to the filament sensor on the Titan Aero.

this attaches to the upper corner of 3030 extrusion with 4 bolts/m5 t nuts

I have also added a wire support that sits on top and uses the 2 bolts going through the top of the corner bracket to hold both pieces in place (I used 5mm x 12mm bolts) This has 3 channels to slide small zip ties through to fasten the hot end wiring and keep it held upright